Duothane FAST A

When mixed with equal parts of DUOTHANE Part B produces a first coat that can be sanded to a powder after 45 minutes. In very cold conditions the ratio of DUOTHANE FAST A should be increased to 2 parts mixed into 1 part DUOTHANE Part B.

USES:

DUOTHANE FAST A is suitable for interior coating of ALL timber species, particularly HARDWOODS.

DUOTHANE FAST A is not suitable for cork floors, use TIMBERSEAL as a sealer coat.

DUOTHANE FAST A is a genuine first coat, it is not just a sealer but produces a coating with a solids content greater than 40%.

DUOTHANE FAST A may be applied over TIMBER SEAL.

FLOOR PREPARATION:

New Floors:

Fine sand to a smooth finish (Not finer than #120 mesh). Hardwoods must not be burnished and grain must remain open. Vacuum thoroughly. Ensure the timber surface if free from dust, wax or oily substances.

Old Floors:

Clean with hot water and detergent .Roughen surface completely with 150 mesh screenback and vacuum thoroughly. Wipe floor with URETHANE COATINGS THINNERS. Test for compatibility by applying DUOTHANE on a small section of floor first. If ‘craters’ or ‘fisheyes’ appear, add 10mls of FLOWMAX Antirejection Fluid per litre of DUOTHANE and refer to FLOWMAX directions.

APPLICATION:

Carefully measure ONE PART of DUOTHANE FAST A to ONE PART DUOTHANE PART B. In very cold conditions curing can be increased by using two parts DUOTHANE FAST A to one part DUOTHANE PART B.

Apply with mohair roller, or lambs wool applicator, or brush. Allow 30-60 minutes to dry. Open doors and windows to increase cure rates. Do NOT return unused material to can.

Sand with a 150 grit screenback and vacuum.

Apply one or two coats of DUOTHANE PART A/DUOTHANE PART B, or MONOTHANE.

Thoroughly clean the mohair roller, lamb’s wool applicator or brush in URETHANE COATINGS CLEANING SOLVENT. Dry all equipment before reusing.

COVERAGE:

10m² per litre. URETHANE COATINGS THINNERS may be added if DUOTHANE has thickened, or if a higher coverage and a thinner coat is required.

MAINTENANCE:

DUOTHANE requires 7-10 days to fully cure. Avoid heavy traffic during this period. Use protective pads under legs of furniture.

Regularly wipe over the floor with an antistatic mop or sweep with a soft bristle broom. We caution against the use of vacuum cleaners, particularly if the bristles are worn as the cleaning head may then scratch the floor. The frequency of cleaning is dependent on the level of traffic, amount of grit carried onto the floor, and activity of children, and pets etc.

To clean your floor, mix up to one cup of Methylated Spirits into a bucket of hot water, and mop the floor, regularly rinsing the mop. If the floor is particularly dirty, wash first with a non abrasive detergent then clean with the Methylated spirits and water solution – this will prevent streaking and smear marks that sometimes remain after use of detergents and/or household cleaners.

SHELF LIFE:

This product is best if used within 12 months from manufacture (refer to batch number), when stored in unopened containers under normal conditions of temperature and humidity.

SAFETY DIRECTIONS:

Usage of this material must be under well ventilated conditions to minimise inhalation of vapours. Wear respirator with filters that conform with AS1716. Asthmatics, the very young, elderly people and pets should leave the site during the first 24 hours. Prevent skin contact by wearing impervious gloves. Breathing of vapour is harmful and may cause lung irritation and allergic respiratory reaction. May irritate skin and eyes. Keep container firmly lidded. In case of spillage, absorb into dry sand or dirt. Remove from work area and cover with water for 24 hours prior to disposal.

WARNING FLAMMABLE:

Contains 250gms per litre of Aromatic Hydrocarbons. This drum contains volatile and flammable solvents and when applying the contents adequate ventilation to the outside must be provided. All potential sources of ignition (open flames, pilot lights, furnaces, spark producing electrical switches, etc.) must be eliminated in or near the working area. DO NOT SMOKE. Keep drum closed when not in use.

FIRST AID:

If affected by inhalation of vapour, remove to fresh air. If breathing difficulty persists or occurs later, consult a doctor and have label ready. If swallowed, do NOT induce vomiting. Give water or milk.

CONTACT DOCTOR OR POISONS INFORMATION CENTRE Australia 131126.

In case of eye contact, flush immediately with water for fifteen minutes and call a doctor. In case of skin contact, remove contaminated clothing and wash skin first with Methylated spirits, then with soap and water.